On Monday, the build began. We finished all sub-assemblies
by soldering the batteries and needed wires to control sensors, motors, and
recording module. After many attempts, we finalized the segment of song that
will play when the box begins to move. The motor shield is attached to the Arduino
board and the schematic for the motor shield is followed when wiring the project
together. The frame that was 3D printed was attached to the R/C car with
screws. The outside “Christmas present” was designed and manufactured then
wrapped with Christmas paper. This was
made out of an old poster board and will rest on top of the laser printed part
to be able to cover the whole R/C car. The whole project has been set up and
functions. We still run into a problem with the sensor not stopping the program
on the board. We have started the paper for our project.
No comments:
Post a Comment